However, the download page for the drivers is so simple that even non-Chinese speakers will find the right download link. Winchiphead (WCH) maintains its website only in Chinese. Silicon Labs maintains a page in English that lists downloadable driver binaries that also contains installation instructions. CH340g is a USB to TTL Converter IC and is used in Arduino UNO, Arduino Nano, nodemcu esp8266 and many other Electronic cir. Note that there is no harm done if you install both drivers even if you currently just use one! If you are not sure which adapter your ESP8266/ESP32 module uses then just install both. There are two commonly used adapters in the wild these days:Įxamples of modules that use the CH340G chip are: In the device manager it will show USB2.0-Serial (as shown in below. Initially connect your hardware having CH340 USB to Serial IC to your PC. ![]() This in turn requires your system to detect the USB-to-Serial (aka USB-to-TTL, aka USB-to-UART) adapter on the ESP8266 or ESP32 module. The CP210x USB to UART Bridge Virtual COM Port (VCP) drivers are required for device operation as a Virtual COM Port to facilitate host communication with. Step By Step Installation of CH340g Drivers. A prerequisite to program ESP*-based modules usually is to establish a communications channel from your development platform (PC, Mac, Linux) to the device over USB.
0 Comments
Leave a Reply. |